Activity
Mon
Wed
Fri
Sun
Dec
Jan
Feb
Mar
Apr
May
Jun
Jul
Aug
Sep
Oct
Nov
What is this?
Less
More
Memberships
Creative 3D Community
Public • 4.3k • Free
4 contributions to Creative 3D Community
Oct 10 in
Hair Dryer
Hey, I tried to model a hair dryer and applied the techniques I learned.
7
3
New comment 29d ago
0 likes • Oct 11
@Mw Siebert Thank You!
Feb 2 in
Tab-Key to Cycle continuity Problem
I am not able to use the Tab-Key to Cycle continuity. Since there is no editable shortcut, what could cause such a problem?
1
11
New comment Feb 5
0 likes • Feb 4
Thank you for your help. Unfortunately, TAb does not respond with Mode: Set All enabled or disabled...
0 likes • Feb 5
Finally found a solution for the Tab-Key continuity Problem. According to Cal_Prog's Post on discord It is possible to change the keybinding for the command palette, but only by modifying the keymap.json file located in the .plasticity folder (C:\Users\YOURNAME\ .plasticity. After deleting the keymap.json file Tab-Key worked normally again :-) I just had to type in all my personal shortcuts again.
Oct '23 in
Helmet
I had fun modeling and, in the meantime, learned a lot. Thanks again for reviewing my data. I'm still going through the Fillet-Fix video. I encountered Fillet issues in a different place. Unfortunately, I couldn't make the fillets as large on the upper cut (see attachment) because they were too close to the ventilation slot. It will surely work better on the next model ;-)
4
2
New comment Nov '23
0 likes • Nov '23
Thank you, I will definitely try my own helmet project. Can you please point out where to find your Plasticity shortcuts?
Oct '23 in
problem patching holes
Hello everyone, I'm currently working on the helmet tutorial and I'm having a problem with patching holes. I've tried setting the cuts multiple times, but I'm having trouble cleanly closing the surface. Can someone please help me?
1
2
New comment Oct '23
1 like • Oct '23
Hello Nikita, Thank you very much for your quick response! I will take a few steps back again:-) Best regards!
1-4 of 4
Active 5d ago
Joined Aug 17, 2023
powered by