10d ago in Need Help ✋
Flow rate and K factor
I’m using the P1P with no AMS. I started experiencing print quality issues. I calibrated it. Worked fine again. Then I think when we changed the spool, we started having issues again. Does anyone know if the k value gets reset after a filament swap? I’m going crazy over this. I can’t figure out how to get back to the quality I had on day 1. Only had the thing 2 months.
1
2 comments
Flow rate and K factor
skool.com/makeit3d
Learn how to design, print, and sell your own 3D Printable designs.
Leaderboard (30-day)
1
+23
2
+14
3
+14
4
+14
5
+12
powered by